Hints for usage and storage of bulk repackaged
Loctite® products
-
Those Loctite® products offered have not been
observed to be reactive to the thermo plastic syringes we have chosen.
-
A quantity of air within the storage vessel is important. For that reason,
10 ml syringes are used for 5 ml packaged quantities.
-
To begin use, pierce the syringe cap as shown below.
-
Holding upright, depress the plunger, displacing air from the syringe.
-
Apply the product, per manufactures instructions (see links to tech data
sheets below)
Following use:
-
Hold syringe upright, plug end, and pull plunger back to original position
as shown below right.
-
This will create a low pressure (vacuum) within the syringe. Releasing
the plug will allow rapid air entry into the syringe, clearing/cleaning
the tip.
-
Replace the tack (below center) and store upright. Refrigeration will prolong
storage life.
-
Extreme heat, and possibly light will shorten storage life.
-
Syringe for Product no. 515 does not have to
be cleared for storage. The entire syringe cap may be removed to dispense
product rather the piercing the cap.
Here are the web addresses where you can view
Technical Data Sheets for these Loctite® Products
http://www.loctite.com/datasheets/tds/Product_290.pdf
http://www.loctite.com/datasheets/tds/Product_242.pdf
http://www.loctite.com/datasheets/tds/Product_271.pdf
http://www.loctite.com/datasheets/tds/Product_290.pdf
http://www.loctite.com/datasheets/tds/Product_515.pdf
http://www.loctite.com/datasheets/tds/Product_609.pdf
http://www.loctite.com/datasheets/tds/Product_648.pdf
|